A true builds kit for a very nice sub 250g parkflyer.
Everything needed to get this bird in the air is included in the kit (except adhesives and electronics of course).

Kit contents:
Laser cut premium balsa and ply sheet parts.
All required sheeting, spars and strip stock
Printed full size plans + build instructions.
3 metres of UltraLite heat activated covering film.
Control horns.
Piano wire for linkages.
Carbon fibre wing retainer pins.

Specs:
Wingspan = 24”
Flying weight = 190 – 240 g


Flight envelope is exceptional for a model of this size, with friendly low speed characteristics, a respectable roll rate and good directional stability.

Performance is sparkling on a 2207 2300kv motor paired with a 5x4.5” prop and 2s 450mah pack, however the model will take a 2207 3200kv and 4s 450mah pack without struggle, opening the door to thrust to weight ratios of more than 4:1 if one desires an affordable pocket rocket.

Regardless of how you set it up this is sure to become a favourite grab n go/travel model - it certainly has become mine.

Postage = $10.50 Australia wide.

Thanks for looking.