A pair of 10S chargers, available separately or together. Both in good working order.
Comes with accessories in pictures, if you need a specific set of main leads I'm happy to make for you, I have heaps of cables and connectors. I have mostly used charging 2 X 5S packs on each charger.
$250 for both chargers or $125 each.
The Cellpro 10s supports up to 10A max charge rates and new faster Auto Charge rates (1.0C, 2.0C, and 3.0C), the 10s is capable of safely charging one or two lithium battery packs at up to a 3C charge rate
For Battery types: Lithium Polymer (1s to 10s balanced), Lithium Ion (1s to 10s balanced), Lithium Manganese (1s to 10s balanced), A123 (LiFePO4) (1s to 10s balanced)
Pack capacity: 100 mAh to 65Ah (charge time limited to max 12 hours) Input voltage: 10-16VDC, reverse polarity protected Input current: 1A to 25A, software limited, user adjustable using PC software Power conversion: DC/DC converter, 62.5 kHz, 80% to 90% efficiency depending on output current Nominal Output Voltage: 3.60, 4.10, and 4.20 volts per cell; 42V maximum Output battery charge current: Adjustable range 100mA to 10A, or 100mA to 4A (node only charging), limited by 25A input current* Continuous max output power: 180W @ +12VDC input, 260W @ +15.7VDC input Voltage calibration: Cell voltage measurements are factory calibrated to a standard traceable to NIST; calibration is to +/- 6 mV Current calibration:Charge current is factory calibrated on a 4A standard; calibration is to +/- 1mA
Measurement accuracy: Voltage resolution: 0.1mV Voltage tolerance: +/- 6mV Charge current: +/- 1% Capacity added to pack: +/- 1% Percent capacity (“Fuel”): +/- 20%
Serial data output: 19.2kbps, 8 bits, 1 start bit, 1 stop bit, no parity Data integrity: Checksum, CRC checking Cooling fans: Single, 8 CFM, 40mm diameter Heat sink: aluminum case, finned Output battery connector: “Cellpro” compatible, 2 x JST PA series, 6 position LCD