RotoMax 1.60 Brushless Motor and 120A HV Opto Esc Both unused. Bag/Box opened.
Turnigy RotoMax 1.60 Brushless Outrunner Motor When combined with a 10s Lipoly battery, 21x13" Propeller and a 120Amp ESC the RotoMax motor will supply punchy, responsive power that only an electric setup can provide.
This motor is specifically suited for carbon fiber & wooden propellers and features an IC style 4 bolt hole design. The shaft has also been tapped to suit a 4mm bolt to make fitting a spinner of your choice easy.
Spec: Battery: 10 Cell /37V RPM: 231kv Max current: 80A Watts: 2960w No load current: 37V/1.47A Internal resistance: 0.028 ohm Pole Count: 24 Weight: 849g Diameter of shaft: 10mm Suggested ESC: 120A 10S Compatible Suggested Prop: 21x13 APC-W
TURNIGY K-Force 120A-HV OPTO V2 5-12S Brushless ESC The Turnigy K-Force series are based on an all new powerful microprocessor usually reserved for high speed car ESC's. The new CPU means ultra fast sync timing, crisper throttle response, less battery load and reduced FET heat buildup. 'HV' indicates this model can handle up to 12S Lipoly.
Spec: Output: Continuous 120A, burst 180A up to 10 seconds. Input Voltage: 5-12 cells lithium battery or 15-36 cells NIMH battery. BEC: None. Control Signal Transmission: Optically coupled system. Max Speed; 2 Pole: 210,000rpm 6 Pole: 70,000rpm 12 pole: 35,000rpm Size: 88mm (L) * 55mm (W) * 15mm (H). Weight: 125g.
Features: * Now with Spark Supressor *High performance microprocessor (24khz) brings out the best compatibility with all kinds of motors and the highest driving efficiency. *Wide-open heatsink design to get the best heat dissipation effect. *Improved Normal, Soft, Very-Soft start modes, compatible with aircraft and helicopter. *Smooth, linear, quick and precise throttle response. *Throttle signal transfered through optically coupled system to avoid the electromagnetic interference. *Multiple protection features: Low-voltage cut-off protection / Over-heat protection / Throttle signal loss protection *Governor mode for helicopter. *The firmware of the ESC can be updated through the USB adapter. *User programmable via Tx, Programming card or pc USB port.
I have also included a set of large bullet connectors and a prop drilling jig to make fitting props to the motor easier.