Designed by Phil Kraft, the original concept of the Ugly Stik was to design a radio controlled aircraft which could be built in an absolute minimum of time and could be considered as expendable.
The airplane that took 3 evenings to design and finish became one of the most built and flown designs in RC!
We have improved on the original design by adding in two plywood wing servo mounts to allow two standard size aileron servos to be mounted in the wing, and a servo tray for mounting standard size servos inside the fuselage.
- Wingspan: 62" / 1581mm - Number of channels: 4 - Recommended engine size: 45 - 60 two stroke - Includes full sized rolled plan and where available the builders original construction article
Materials Required For Completion:
- 1.5 x 75 x 915 Balsa Sheet x 4 - 3.0 x 100 x 915 Balsa Sheet x 2 - 3.0 x 5.0 x 915 Balsa Sticks x 2 - 5.0 x 5.0 x 915 Balsa Sticks x 4 - 9.5 x 9.5 x 915 Balsa Sticks x 2 - 6.5 x 12.5 x 915 Spruce x 5
We can package up a complete wood kit including all of the materials in the required list for an additional NZ $62.80)
The laser cut short kits include all of the shaped parts in balsa and ply which would normally require the builder to cut them from sheets. Items such as formers, wing ribs and other shaped pieces are all precisely laser cut. This leaves you to purchase only the sticks, spruce or balsa sheets you need to complete the kit, some of which you may already have on-hand.
All kits are proudly made in NZ! We hand select our wood stock for each kitset from the best Balsa Wood from Papua New Guinea and European Plywoods.
* Note that the picture of the complete aircraft is indicative of it's completed appearance. The kitset requires building and supply of all finishing materials & hardware.