General specifications: Length: 1488 mm / 58,6 inch Wingspan: 1700mm / 66.9 inch Height: 510 mm / 20.1 inch Wing area: 51.4 dm2 / 5.53 sq ft Wing loading: 71.9 g/dm2 / 23.6 oz at sq ft Center of gravity: 102mm / 4.01 in from LE See CG tags on wings... Airfoil: 3DLabPrint SPT02 Weight of all printed parts: 2060 g / 72.7 oz Takeoff weight (6s 4500mAh Li-Pol): 3700 g / 130.5 oz Max takeoff weight: 4200 g / 148.2 oz Never exceed speed, VNE: 160 km/h / 99.4 mph Design maneuvering speed, VA: 120 km/h / 74.6 mph Stall speed, VS(full flaps): 38 km/h / 23.6 mph
Throttle Ailerons Elevator Rudder Flaps Retractable landing gear no included Spinner for 3 blade prop It comes in sections that are simply glued together is CA glue. During assembly you may need to trim or sand the section join lines and use some filter. Motor mount for two different motor options all 6s This is an airframe only you need to supply. Servos 6x Hitec HS-82 or similar, ESC Push rods etc Retractable landing gear and wheels Receiver CA glue and accelerator The photo shows an assembled Spitfire ready for painting the actual colour of the airframe may vary for the picture.